115+ Bauder Flat Roof Build Up

www.scribd.com

```html

Opening: Building a Simple Birdhouse

Building a birdhouse is a rewarding DIY project that provides shelter for birds and adds charm to your yard. This guide will walk you through the steps to create a basic birdhouse using readily available materials.

Step 1: Gather Your Materials

• Lumber: A single piece of untreated softwood like pine or cedar (approximately 1" x 6" x 6 feet) is a good starting point. Cedar is more weather-resistant.
• Fasteners: Galvanized nails or exterior wood screws (1 1/4" 1 5/8")
• Tools: Saw (hand saw or power saw), drill with various sized bits, measuring tape, pencil, safety glasses, sandpaper, hammer or screwdriver.

Step 2: Cut the Wood Pieces Here's a sample cutting list. Adjust dimensions as needed based on your lumber size and desired birdhouse size. All dimensions are approximate.

• Front: 6" wide x 8" high
• Back: 6" wide x 10" high
• Sides (x2): 6" wide, sloping from 8" high in the back to 6" high in the front
• Bottom: 6" wide x 6" deep
• Roof (x2): 6" wide x 7" deep

Carefully measure and cut each piece according to your chosen dimensions. Safety glasses are a must!

Step 3: Assemble the Birdhouse Body Start by attaching the sides to the bottom piece. Use nails or screws to secure them together. Ensure the angled sides are positioned correctly, with the taller portion towards the back. Then, attach the front and back pieces to the sides and bottom, forming the box shape.

Step 4: Create the Entrance Hole Determine the size of the entrance hole based on the type of bird you want to attract. Common sizes are:

• Wrens: 1 1/8"
• Chickadees: 1 1/4"
• Nuthatches: 1 1/4"
• Bluebirds: 1 1/2"

Use a drill with a hole saw or spade bit to create the entrance hole in the center of the front piece, a few inches below the top. Sand the edges of the hole smooth to prevent injury to the birds.

Step 5: Attach the Roof Attach the roof pieces to the top of the birdhouse. Overlap them slightly at the peak to create a small overhang. Secure with nails or screws. Ensure the roof overhangs the front to provide some protection from the rain.

Step 6: Add Drainage and Ventilation Drill a few small drainage holes (1/4" diameter) in the bottom of the birdhouse to prevent water accumulation. Also, drill a couple of small ventilation holes (1/4" diameter) near the top of the sides to improve air circulation.

Step 7: Sand and Finish (Optional) Sand any rough edges or splinters on the birdhouse. You can leave the birdhouse unfinished, or you can apply a non-toxic, water-based stain or paint to the exterior. Avoid using bright colors or glossy finishes, as these may deter birds. Do not paint the interior.

Step 8: Mounting Your Birdhouse Consider where you want to place the birdhouse. Options include mounting it on a pole, hanging it from a tree branch, or attaching it to a building. Ensure the location is safe from predators and provides adequate protection from the elements. Add a mounting bracket or pre-drill holes for screws depending on your chosen method.

Conclusion: Enjoy Your Birdhouse Congratulations! You've built a simple birdhouse. Place it in your yard and observe which birds take up residence. Remember to clean out the birdhouse annually, usually after nesting season, to remove old nests and debris.

```

Bauder Flatroof Systems Productoverview 0119 En

www.scribd.com

Bauder Total Roof System Inverted With Bauderjfri Premium

www.bauder.co.uk

Bauder Roof Membrane

doorroof.deojz.com

Share this